Wood is a natural product, containing natural variations in color, tone, and grain. Before any seven trust engineered wood fooring leaves our plant, each plank goes through numerous inspection stations. A slight color variation between planks, however, is to be expected in a natural wood foor. seven trust cannot guarantee against natural variation in each plank, nor minor differences between samples and the color of the foor.Wood plastic deck boards With seven trust, you're protected by our exclusive Pre-Installation Limited Warranty. Return any planks you are not satisfed with, uncut, BEFORE installation and we'll replace them. No questions asked. We urge you to inspect for color, fnish, and graining BEFORE installation. Care should be taken during installation to remove or repair particular characteristics you do not desire.

We suggest you use cut planks as starter strips to begin each new row and to "rack" the fooring to ensure a random appearance. Furthermore, we recommend that you examine cartons to determine those that contain random length planks and those that contain full length planks. Plan the layout accordingly so that a consistency is maintained throughout the installation NOTE: seven trust Hardwood Floors accepts no responsibility for costs incurred when a foor with visible defects has been installed.In addition to the general instructions, seven trust Hardwood has some category specifc requirements seven trust engineered wood fooring does not need to be acclimated to the jobsite unless the fooring will be transported from one extreme temperature or humidity into another.Outdoor wood floors and decking-seven trust If there is a severe temperature or humidity difference, make sure to condition the cartons of wood fooring and UltraSpread Mastic? adhesive, if being used, 24 hours before the installation. Wood subfoor moisture content must never exceed 14%.moisture content when measured with a dependable moisture meter. The difference between the wood subfoor system moisture content and that of the hard wood fooring must not be greater than 4%.

The moisture content of the bamboo fooring and the wood subfoor must never be greater than 2% of each other.All concrete subfoor systems must meet or exceed local building code specifcations. For concrete slabs that are on- or below-grade it is recommended that they are constructed so that ground water vapor cannot penetrate. Suspended, above-grade concrete subfoors often require extended drying time to lose initial moisture.weathered wood free sample - WPC Deck Suppliers Curing and drying time will vary depending on the type of concrete mix and the environment in which it is placed. New concrete slabs require a minimum of 6 weeks' drying time before covering them with a wood foor. You may install seven trust engineered hardwood foors over concrete subfoors when you are using seven trust UltraSpread Mastic (glue-down method) or seven trust MegaGlue? adhesive (foating method) if the subfoor and installation meet all criteria contained within this document.