Blockboard: moisture effect, can not be directly painting
Middle Blockboard natural wood core is bonded, the thin veneer glue on both sides, is one of the most important decoration materials. You can make furniture and wooden doors and door pocket bag, heating cover, pelmet, with its waterproof function better. In the selection, look at its internal timber, not too broken, the gap between the wood block board about 3mm appropriate.post and rail fencing suppliers Because the surface of the exposed wood pretty, little direct painting, usually affixed to plywood veneer. With its production of furniture, plywood glued panels and painting through two processes, the cost is higher.
Integrated board: not easily deformed
This is a new kind of wood materials, the use of high-quality large-diameter logs entrance intensive processing, as fingers interlaced stitching wood. Because of different processes, such plates superior environmental performance, including the amount of formaldehyde is promised Blockboard 1/8. On the other hand, this spruce wood produced by the United States can be directly painted sheet metal, painting, eliminating the need for a process than a block board.
MDF poor nail holding power than particleboard
Particleboard is made of natural wood into pellets after crushing destroyed by pressed into boards, is the main material of the cabinet. MDF wood powder after use by pressing, flatness better, but poor moisture resistance.panneling posts plastic Contrast, the nail holding power than particleboard MDF poor, if after tighten loose screws, because the strength of MDF is not high, it is difficult and then fixed, and therefore rarely used to make the cabinet.
Veneer plywood: easy and cheap
Plywood, also known as plywood and plywood, different names in different layers, which mainly depends on the merits of raw materials. Home improvement is now mainly used in plywood veneer, that the factory has a very thin wood veneer plywood affixed. Facilitate the use of veneer plywood, cheap prices.