ulti-mount ii? Post mounting System for Clubhouse Plus and Elite Railing for concrete: 1. Lay out locations for posts. 2. Use base plate as a template and mark the four corner holes for the concrete Wedge Bolt? anchors. (Figure 18) 3. Drill the marked holes using a 1/4"masonry drill bit. Drill the hole into the base to a minimum depth of 3-1/2". Clear dust and debris from hole. 4. Align the base plate over the drilled holes. 5. Position the base trim over the top of the base plate. composit patio durable fence(Figure 19) 6. Place the post mount into the base trim, and line up the holes. (Figure 20) Screw the 5/16"leveling bolts into the four tapped holes. If needed, adjust the bolts to straighten the post. (Figure 21) 7. Insert the four concrete Wedge Bolt anchors into the holes located at the corners of the bottom plate. Begin to tighten each of the Wedge Bolt anchors by rotating clockwise and applying pressure in toward the base. This will engage the first few threads as the Wedge Bolt anchor begins to advance.

Continue to tighten until the head of each Wedge Bolt anchor is firmly seated against the base plate. do not over tighten bolts, as shearing of the bolt may occur. 8. Slide post cover over the post mount until it seats into the base trim. The post sizing stabilizers will permanently secure the post cover in the proper position. 9. VERy imPoRtant: insert a 4" x 4"wood blocking to fill cavity between ulti-mount and top of post cover. this filler allows bracket screws a solid structure to grip.commercial application of composite decking SECondaRy hand RaiL foR uSE With ELitE & PLuS StaiR RaiLS 1-1/2" Secondary handrail installation instructions The 1-1/2" system complies with ADA Requirements. Properly installed, both systems exceed current ICC test requirements. Sketch a layout of the new secondary railing in relationship to the existing railing noting the various pieces you will need and where you will need them. Check to see if you have all the piecesthat you will need. Determine the height of the railing (35"to 38"to the top, for commercial applications) and check how that height works coming down or up steps. Establish a place to begin.

NOTE: If there is an inside corner you must start there first. A 1. For each screw drill a counter sink the depth of the vinyl using a 9/32" bit. 2. Drill a thru hole using a 5/32" bit. Do not rely on self drilling capabilities of the connector screws. 3. Using the #10 x 1" connector screw provided, fully seat into the counter sink.composite decking in south australia Finishing Connections On bottom of railing use (2) screws on either side of a connector or (2) screws on a return. "P" LOOP INSTALLATION STEP 1 STEP 2 34" to 38" 23" 12" A 90o Outside Corner Preformed Bends 90? 36? 5? 32? Custom bends are available. Ask your dealer for details. Determine the length to cut the handrail which is joined to the modified post return, by inserting the next piece of railing or elbow into the corner and laying it over the adjacent piece on the other side of the corner. This will establish a mark to cut the railing.